Shared or group IKE IDs can be used to configure a single VPN Users need to reauthenticate during IKE phase 1 rekeys. Software, administrator rights are required.
IKE in virtual routers or in virtual routing and forwardingĪuto route insertion (ARI) is not supported.Īdministrator rights are required to install Pulse client AttributesĬan be provided from a local address pool. VPN monitoringĮxtended authentication (XAuth) with mode configurationĪuthentication is supported from a local profile. VPN traffic initiated from the SRX gateway is not supported.ĭead peer detection (DPD) is supported. VPN traffic can only be initiated from the remote client. Only preshared keys are supported for authentication.Īggressive mode is supported for IKE phase 1 exchanges. IPv6 traffic and tunnels are not supported. Only IPv4 traffic and IPv4-in-IPv4 tunnels are supported. Route-based VPNsĪre not supported with dynamic VPN tunnels. Options when configuring dynamic VPN tunnels: The following list describes the requirements and supported In the same way as traditional IPsec VPN tunnels. Understanding Local Authentication and Address Assignment.Understanding Remote Client Access to the VPN.
See the Software Installation and Upgrade
If more than two simultaneous user connections are required,Ī dynamic VPN license must be installed on the SRX Series gateway. To create and manage a secure end-to-site VPN tunnel to the gateway. The Layer 3 remote access client uses client-sideĬonfiguration settings that it receives from the SRX Series gateway Through an external RADIUS server or a local IP address pool configured Pulse SecureĬlient software is used for VPN access.
Known as remote access VPN or IPsec VPN client. To Enable Remote Access to a Corporate Network